|
Post by Lonely Wolf Forge on Jul 7, 2015 2:34:44 GMT
|
|
|
Post by L Driggers (fallen) on Jul 7, 2015 4:13:38 GMT
I have the propane burner you've got its too small for a 20lb propane tank forge. You would be better off using a DIY reils type 3/4in burner, it will run a 20 propane tank forge. Can't see how far you've got the burner inside the forge, or how much kaowool you have it lined with, 2inches is enough. The burner should not go pass the insulation. Are you using a pressure regulator you need to, to control the temp. Also do you have a back door cut into it. Lastly did you put a reflective coating on the kaowool, if not you have dangerous fibers floating around.
|
|
|
Post by freq on Jul 7, 2015 5:30:39 GMT
looks like a good start so far, what steel are you using?
|
|
|
Post by Lonely Wolf Forge on Jul 7, 2015 15:12:07 GMT
1075 carbon
|
|