Kuya
Registered
Posts: 1,396
|
Post by Kuya on Jul 10, 2012 1:10:36 GMT
I put Renaissance Wax on one of my swords, the one I don't plan on cutting stuff with. Is there anything else I need to do afterward? Like do I have to oil it as well over the Renaissance Wax?
I'm a little nervous, because I can't tell if I put it on right too. The directions say to use it sparingly, so I didn't glob a bunch of it onto the cloth and then smear layers of it over the blade... but it's so clear and thin, I can't actually tell if it's on everywhere.
|
|
Sam H
Member
Posts: 1,099
|
Post by Sam H on Jul 10, 2012 2:24:36 GMT
Dude you did it so very wrong! You're supposed to heat the blade till its around 250 degrees then apply the wax with a cloth that's damp with soapy water. After you've done that and allowed the blade and wax to cool you then need to spray it with water and buff till the wax is smooth and clear. This all makes sure that there aren't any air bubbles beneath the wax coating you just put on your sword blade and also makes it shiny for display. If you find bubbles or believe the coat isn't even you'll have to reheat the blade to 250 degrees, wipe off the molten wax and re-apply. Ok I was just kidding. I haven't ever actually used Ren Wax so I couldn't tell you how to properly apply it. I have heard though you need to make sure there isn't any air trapped between the wax and the blade or else you'll get a pocket of corrosion there. Personally I use Militec-1 grease on my swords and I haven't had any issue with rust, even swords stored for months and years without being cleaned. Of course if you're intent on a good wax job just go ask your local stripper where you can find one. :lol:
|
|
|
Post by junon on Jul 10, 2012 4:25:00 GMT
I use ren wax for all my swords.
I usually clean up the sword first using 95% alcohol and dried it using cleaning paper. After that I applied ren wax as instructed (thin layer).
I have never need to apply oil anymore and as far as I can tell, my sword are pretty much rust free for month...
I usually check my blade on weekly basis and re-apply the ren wax every month or two (just to be safe; I live in tropical climate, so it's very humid around here).
|
|
|
Post by Dave Kelly on Jul 10, 2012 7:09:00 GMT
Practice. After you've done it for a while you'll develop an "eye" for it. I use a foam pad. Work on the blade first then the hilt. Coat then buff out. Hilt takes a bit more time working around things. Soft microfiber cloths do great for buffing. RenWax is expensive. It's chief advantage is it's long lasting "clean" non-staining properties. There are cheaper options for steel. Automotive spray silicon is quick and dirty. ( Not recommended for paint and leather) Like I said, after you've done it for a while you'll get the hang of it. Another cheap maintenance suggestion borrowed from others is to keep some felt cloths impregnated with 3 in 1 oil in a baggie and every couple of months swab your blades and scabbards. Works just fine. If you live in a modern, centrally air conditioned home your maintennece needs are very light as climate changes, humidity and dust are the long term issues for corrosion attacking your steel. Adjust your maint schedule accordingly. If your out on campaign at the moment, checking daily is wise...
|
|