Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 7, 2009 2:34:16 GMT
Does anyone know the measurements on this sword? Im just gonna put X's on the dimension labels im talking about cause i feel like that would be easier. Ill throw up a paint picture to illustrate.. Thanks ahead of time! Pommel Thickness, Blade thickness at crossguard and near the point, and also Pommel Width:
|
|
|
Post by YlliwCir on Dec 7, 2009 2:55:03 GMT
Ben I'm gonna assume (I know, I know) that you mean the Hanwei hand and a half (Albrecht II) since that what your picture looks like. I get the pommel on mine at 2 5/8 inches wide by 1 5/8 thick. Can't give you an accurate measure on the blade as I don't have any calipers.
The Bastard is a whole different sword. I got that one too if you need some info on it.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 7, 2009 3:22:12 GMT
Thanks alot for the answer Ric, but i was actually referring to the tinker bastard sword, sorry if there was some ambiguity. Ill actually edit that now.. Im relatively new to the whole Euro/Medieval sword thing (My experience is with Japanese)
|
|
|
Post by YlliwCir on Dec 7, 2009 3:36:54 GMT
LOL, it was my bad, Ben. That one didn't occur to me. I can see the resemblance now. That thing they say about assuming.......
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 7, 2009 3:46:51 GMT
Haha, it's no problem, it was probably my fault anyway. I'm not so used to the Medieval sword racket yet, and the reason im asking about the measurements is cause im gonna atteempt to make a sword similar to this one. I like the looks of parts of it
|
|
|
Post by YlliwCir on Dec 7, 2009 3:49:37 GMT
Ah, cool. I look forward to seeing the result.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 8, 2009 22:08:31 GMT
again in the interest of being precise, you mean the fullered one?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 9, 2009 1:13:31 GMT
Yeah, the fullered version is way better looking than the non-fullered one
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Dec 10, 2009 15:07:13 GMT
These are not posted on his site? I guess they wouldn't be...but it should share same specs as his full Tinkerline Bastard as that is what it is modeled after.
|
|