Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 29, 2009 13:16:01 GMT
Does anyone else find it less than opportune that it is so much harder to do custom work on a European sword.
Does anyone know a way to get a wheel pommel for a tinker hanwei longsword?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 29, 2009 13:52:20 GMT
I myself am looking for a pommel for a sword its near impossible to find them so I drew up a Type J@I now im looking for a local Metal shop to do some leath work I think that could be your best bet also
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 29, 2009 19:29:31 GMT
I wonder how much that might cost
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 29, 2009 23:42:43 GMT
It should not cost that much The leath work is pretty straight forward and material cost well that might be free if they have scrap metal around all you will have to do is drill and thread the pommel sand and polish to your liking of course the weight of the pommel is an important factor Tinker would give you the best advice on the pommel for that sword
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 31, 2009 1:06:09 GMT
Wheel pommel? Just cut a slice off of round bar.....
|
|