christain
Member
It's the steel on the inside that counts.
Posts: 2,835
|
Post by christain on Sept 21, 2017 16:58:40 GMT
Hey all...I'm about to start a little project and would like your thoughts. I'm planning on painting some of my armor, mostly with small designs, but some entire pieces. What would be the best way to get any and all oil off the steel. Would some mild degreaser followed by rubbing alcohol work, you think? Some of the designs will be done in oil-base paint, like an artist would use. Also, what about a clear coat over the paint? If this has already been addressed here in the forums, could someone direct me where to look? Thanks, y'all. .....Chris
|
|
|
Post by Sir Thorfinn on Sept 29, 2017 16:23:10 GMT
So many variables... So do you plan to use the armor, or just display? This could make a difference in how much you need to do. Here's what I do to high useage Mild steel armor (SCA) Sand/polish until the metal is the finish you want, Degrease - Dawn soap works great. Acetone if you're into overkill degreasing. If you are doing designs, you may want to sand *just those areas* to help paint stick. I recommend using masking tape to avoid unsightly over sanding.
Paint away. Degrease again so your hand prints don't cause more rust. Seal the metal, with either clear wax or if you're not wearing it, lacquer. And pay heed to if the lacquer is gloss, matte, semigloss etc.
That's about it... Luck and post pics!
|
|
christain
Member
It's the steel on the inside that counts.
Posts: 2,835
|
Post by christain on Sept 29, 2017 17:34:32 GMT
Thank you! I would have never thought about Dawn soap! I'll give it a shot. The largest piece will be a helmet that I plan on having professionally powder-coated. Tough stuff, that. ......Chris
|
|
|
Post by Sir Thorfinn on Oct 9, 2017 14:55:36 GMT
Powder coat is nice, but doesn't hold up to combat... If you're going for black, have it commercially blued. Or, you can do it yourself
|
|